LG Refrigerator Change Water Filter Light On?


If you’ve recently noticed the “water filter” warning light on your LG refrigerator then it is likely time to replace the filter. Sometimes you might also notice that the water pressure is getting lower and it is taking more time to fill your cup. This is because sediment clogs up the filter so the water has trouble getting through it. You can pick up the LG LT700P Replacement Refrigerator Water Filter (also known as part# ADQ36006101) from amazon here.

Filter replacement is quick and easy – Eliminates harmful chemicals to provide safer drinking water – System tested and certified by NSF International against NSF/ANSI Standard 42 and Standard 53 for reduction of substances found in – Have great tasting water for just pennies on the gallon

The LG LT700P fits the new 2010 LG refrigerators with forward french doors and four-door dispensing models including the LFX25978SB, LFX25978ST, LFX25978SW, LFX25991ST, LFX28968SB, LFX28968ST, LFX28968SW, LFX28978SB, LFX28978ST, LFX28978SW, LFX28979SB, LFX28979ST, LFX28979SW, LFX28991ST, LFX28995ST, LFX29927SB, LFX29927ST, LFX29927SW, LFX29945ST, LFX31925SB, LFX31925ST, LFX31925SW, LFX31935ST, LFX31945ST, LFX31995ST, LFX32945ST, LFX33974ST, LMX25986SB, LMX25986ST, LMX25986SW, LMX25988SB, LMX25988ST, LMX25988SW, LMX28988SB, LMX28988ST, LMX28988SW, LMX30995ST, LMX31985ST, LSFD2591ST, LSSB2791ST, LFX25976SW

Subscribe
Notify of
guest
53 Comments
Oldest
Newest Most Voted
Inline Feedbacks
View all comments
Beverly Nicklin

I changed the filter and the light will not stop blinking. I have helded the button beside the light and nothing happens.

Anonymous

I had to reset the filter button, first it resets the light, then you have to do it again and the filter should reset. I had to do it a few times.

jJim Munro

I’ve replaced the water filter with appropriate #LT700P and the water stream seems OK, however the blinking light on the left front door does not stop blinking after I’ve pressed the front button numerous times for several seconds, (beyond the recommended 3 secs.). I’ve also removed the new filter & replaced, as prescribed, but no change.
HELP?

Bruce Ryan

Press the Water Filter and Express Freeze buttons at the same time for three seconds.

Tom

THANK YOU!!! This worked for me.

Karla

You are a genius!!! Thank you so much Bruce Ryan, it worked?

Betty

That works ! I tried everything else but this was the trick.

Ida

Thank you Thank you it worked. Why couldn’t the LG support team tell me that.

Dan

That worked for me too! Thanks!

Jim

Thank you I was driving myself crazy trying to figure it out. Had replaced filter before and had no problems. You the man..man

james

no didn’t work

Gregg

I went through this and pressed the reset with no luck. When I kept the door open and pressed the rest it worked. Don’t know why.

Ferone

I just did the procedure as advised and it did not work, however what you advised did work. Thank you!

Anna Marie

Same problem with the filter light and this worked for me too!

Chris

Worked for me, with the door open. Why can’t LG post this fix???

Sherri

Worked for me if I pressed reset with door open.

Joseph Schimmel

Water filter indicator flashing. Pretty sure it has not been six months since I replaced the filter. Then replace filter today 5/15/17 and water filter indicator light still flashing. What’s going on?

Cassidy

I think there is a way to reset the flashing filter light. It goes off every 6 months independent of the filter change. Just google the model number and “reset filter light” and it’ll have something.

Gary Esraelian

hold the the button in until sound comes the hold for 3-5 sec the light will go out it worked on mine.

Joni

Thanks Gary! It worked

Anonymous

Thanks, Gary. It worked on mine, too

SD

Thank you!

Mary

Thank you! Your suggestion worked! Was driving me crazy!

Anonymous

yes, thank you!

Anonymous

Thank you, it works

Lucy Hennessey

I replaced my water filter. I held the reset button for more than 3 seconds and no light goes on at all. What can I do?

Anonymous

I had to hold both the ‘change filter’ and ‘express freeze’ at the same time. The buttons are stacked on the panel.

Tom Brady

I have replaced my clean water filter and the light on the door continues to blink. I replaced the new filter with a new filter and the light continues to blink. Please help!!!

Cassidy

Sometimes you need to reset the filter light as it doesn’t know when you replaced the filter. It is generally holding one of the front buttons for a couple of seconds. Post your model number and we can help look it up if necessary.

Tom Brady

I tried holding the filter for 3 seconds and that worked. Thank you for this page to share and receive info on these products.

Joan

Cannot get the light to stop blinking after changing the water filter. Have tried everything.

Cassidy

Try holding in the filter or one of the other buttons for few seconds.

Jennifer

On my model, LG says to hold the express freeze button for 3 seconds to reset the water filter light, but that didn’t work. I had to hold the air filter reset button for 3 seconds instead.

Anonymous

Hope this is helpful. I held the filter button for about 25 seconds before it reset.

Marie

I’m holding the freakin light won’t stop blinking!!! It’s not the light, it’s the words by the light you press!!!! DUH!! I was getting pretty mad ?

Mike Gray

Thanks. How stupid is that??? It worked though.
Mike

David

Its the words below the flashing lights

Bob

replace ice light will not go out no matter how long I hold in the filter reset button in. lfxs24623s

Mary Sullivan

LFXS24663 – Changed the water filter and that’s working fine. But the water filter light on the door won’t stop blinking. It stops after being pressed for about 15 seconds, but so do all the other lights. Open the door, and it’s flashing again.

Lars Taavola

Pressing the light on the door of LG model LSXS224235/00 does not work. Neither does unplugging the unit for a brief time. What can I do?

Lars

O. Sweet

Just changed water and fresh air filter. I cannot get rid of the word “replace” under the fresh air symbol. I have held the fresh air button for longer than 3 seconds. Any ideas? Model LMXS27626 french door refrig. Also held down the water filter for more than 3 seconds. Thk you

Ken

I replaced water filter Works fine. The control panel no longer showS the months until replacement needed. Have tried all the button pushing. Nothing works.

Ken

I replaced water filter Works fine. The control panel no longer showS the months until replacement needed. Have tried all the button pushing. Nothing works.

Chris

I had to open the door to ensure my change filter light came on. Next I closed the door. I then immediately pushed both the words to water filter and express freeze for roughly 5 seconds. I heard a beeping sound and let go after the words were no longer lit.

Larry

That worked for me Chris! Thanks.

Alice

People keep saying to press the express freeze button, but I don’t have that button. Not only is there a 0 lit up indicating the filter needs to be replaced, which I have done, but now the light where the water comes out will not go off.

William byrnes

I don’t have that express button
On
My lg

terry purdy

Tried everything here but filter light still flashes on a S27626S

Mark

If you are still having this problem, try putting the fridge in display mode (see manual) and then take back out of display mode. This worked for getting rid of the flashing light, but the light button doesn’t turn on the exterior light, so I think that button is broken…at least the flashing stopped.

Donald Furo

we just changed the water filter on our LG French door refrigerator, model LMXS27626. It is still telling us to change the filter., also I noticed in the last few days, there is mositure on the items in the fridge, and the shelves.??

Barry

LG refrigerators are now using inverter compressors which are overheating if temperature gets too hot. They also suffer from blockages in freezer evaporator

Greg Hendzel

you are awesome. so aggravating – LG is clueless. thaniks.

w. bloodgo

Scroll far down on this scroll and you’ll find the solution from a smart poster: press the WORDS under the flashing light signals for 3-5 seconds and the lights will go off. LG doesn’t make clear what they mean by “Press the Filter Button.” There is no button on my model.